Land Pride RC2515
|Surpassed rugged industry
|All Land Pride Cutters have been designed and tested and meet rigorous voluntary
|Factory assembled||Saves customer set-up time and money.|
|5 Year gearbox warranty||Shows confidence in gearbox integrity.|
|160 HP Divider gearbox
and 75 HP wing gearboxes
|A rugged heavy built gearboxes capable of handling heavy cutting applications.|
|Gearbox Seal Protection||Gearbox bottom seal protection for longer bearing life.|
|Input driveline: Cat. 4 CV||Driveline is matched just right for capacity of tractor. Constant velocity (CV) U-joint
allows for 80 degree turns without doing damage to the driveline.
|Easy greasable drivelines||Drivelines have access holes for greasing the U-joints and to grease the inner profiles.|
|2 Plate slip-clutch||Protects drivelines and gearboxes by slipping clutches rather than twisting the driveline
when impacts are encountered.
|15,000 FPM High blade tip speed||Allows clean cutting of material and even distribution.|
|6" Blade overlap||Eliminates skipping during turns.|
|11 1/4" Deck height||Handles heavy cutting, which reduces balling-up of cut material under the deck.|
|3/16" Gauge Stump jumper backed
with a 1" thick mounting bar
|Allows cutter to slide over obstructions protecting gearbox output shaft & bottom seal.|
|10 Gauge smooth deck top||Reduces accumulation of debris and is easier and faster to clean.|
|1/4" Plate side skirt||Reduces debris piercing possibilities.|
|Low hitch weight||Less drawbar wear. Less ballast required. Works well with lighter tractors.|
|Dual remote hydraulics||Easy to operate. Fits most tractors, only two duplex outlets required to lift wings and
change cutting height separately.
|Hinged wing sections||Allows cutter to follow terrain. Ideal for rough ground where hillsides, ditches and
hollows can cause uneven cutting. Wings will hinge 20o down.
|7/8" Solid hinge rods||Gives great strength to the cutter from front to rear, and in the hinge area itself.|
|Wing transport locks||Holds transport wings in the folded-up position in case of hydraulic pressure loss.|
|Enclosed front to rear dual leveling
|Dual leveling rods enable the cutter to pull equally on the rear axle during travel over
rough terrain. Many competitors only use one leveling rod.
|5-Bolt hubs||5-Bolt hubs makes the wheel assembly more durable and longer lasting.|
|Drain holes in wheel rims||Allows water to drain from wheels mounted on folded-up wings.
Helps prevent paint deterioration and rusting to the wheel rims.
|Spring-cushioned lift cylinder||Cushions loads on drawbar.|
|Replaceable wheel spindles||Wheel spindles can be replaced when damaged without replacing the entire axle.
Simply remove two bolts to replace damaged spindle.
|7/8" Leveling rods||Large diameter leveling rods provide superior supporting strength over rough terrain.|
|Airplane tires||Gives better cushion while transporting and provides flotation in soft ground.|